I am sanding an upstairs floor, as part of it I am going to fill the floorboard gaps.
I have seen LECOL 7500 recommended which you mix with the sanded sawdust to form a paste. However, I will have to hire the sander and as I have to sand again after filling running out of filler mid job will not be good.
The room is a bout 10 m2 (mid sized bedroom). I will install slivers in the big gaps so the filler is theoretically just for the small stuff. The boards are not T&G (if that makes a difference).
Any Ideas on how much Lecol will be needed?
Thanks in advance.
Cheers,
Richard B.
I have seen LECOL 7500 recommended which you mix with the sanded sawdust to form a paste. However, I will have to hire the sander and as I have to sand again after filling running out of filler mid job will not be good.
The room is a bout 10 m2 (mid sized bedroom). I will install slivers in the big gaps so the filler is theoretically just for the small stuff. The boards are not T&G (if that makes a difference).
Any Ideas on how much Lecol will be needed?
Thanks in advance.
Cheers,
Richard B.