I had a key safe that failed.
In trying to remove it, the bolts holding it sheared off and 4 quite large holes have been left behind
The wall here is sandstone
Any thoughts as to what I can use to fill these holes - and if I can reasonably reattach an unbroken safe back into the same location? I was wondering
about some kind of 2 part epoxy and embedding rawlplugs into it before it cured.....but looking at it it must be quite close to the egde of the stone - so maybe I am better
filling and leaving without the safe attached.....
In trying to remove it, the bolts holding it sheared off and 4 quite large holes have been left behind
The wall here is sandstone
Any thoughts as to what I can use to fill these holes - and if I can reasonably reattach an unbroken safe back into the same location? I was wondering
about some kind of 2 part epoxy and embedding rawlplugs into it before it cured.....but looking at it it must be quite close to the egde of the stone - so maybe I am better
filling and leaving without the safe attached.....