Hi there, I'd like to install a multifuel stove in a reception rm of our early victorian house & need advice on how to proceed. The 'WHICH LOG BURNING STOVE' blog was interesting & I'd already decided on the Morse 'squirrel'. There's a gas fireplace in the recess at the moment. Should my first move be to get a builder in to remove the gas fire, sort out the chimney lining & surround etc? I understand we need to get council approval also - is this before work or after installation? I'd appreciate any guidance you have as I don't know where to start :? !
- Thread starter 29pearson
- Start date
bower1
Member
- Messages
- 132
- Location
- Dorset, UK
You can either inform the council before starting (which will cost for a "building notice") or use a HETAS approved installer, who should install the stove and the chimney liner.
You could get a builder to do the initial work on the fireplace, but make sure you (or they) are clear about the building regulations on the size of the hearth.
Try speaking to a local firm selling the stove about installation.
You could get a builder to do the initial work on the fireplace, but make sure you (or they) are clear about the building regulations on the size of the hearth.
Try speaking to a local firm selling the stove about installation.
Penners
Member
- Messages
- 17,294
- Location
- Suffolk, England
I would certainly agree with bower1 that you'd be better advised to use a specialist installer, rather than an ordinary builder. Get them to come and have a look at the current installation, and they will advise you on how best to proceed with the removal and new installation.
stickybeak
Member
- Messages
- 109
- Location
- South East
.
Fantastic thanks for all of your helpful comments. I'll use the HETAS approved installer route, it's good to know the council don't need to be involved in everything. Stickybeak, I reacon the gas fire was installed about 10ish years ago so not a heritage piece & asbestos shouldn't be a problem. Damn ugly though! ...Any takers for it??...